The proper bleeding procedures for slave cylinders without bleed screws is as follows:

1. Push the slave cylinder pushrod inward and disconnect both bands of the retaining strap to enable the pushrod to fully extend.
2. Tilt the slave cylinder to a 45° angle.
3. Insert the master cylinder line into the slave cylinder port.

How do I get the pressure back in my clutch?

Place the other end in an empty water bottle and top off the master cylinder with brake fluid. Pump the clutch pedal – If you have a friend with you, have them get in the driver’s seat and pump the clutch pedal 10 to 15 times to build pressure. Then have them press and hold the clutch pedal completely down.

How do you bleed the air out of a clutch master cylinder?

How to Bleed a Clutch Master Cylinder (7 Easy Steps)

1. 1) Prepare to Bleed the System.
2. 2) Open the Bleeder Valve and Purge Air.
3. 3) Close the Bleeder Valve.
4. 4) Repeat Until No Air Remains.
5. 5) Top Off Clutch Fluid Reservoir.
6. 6) Test Clutch Pedal.
7. 7) Clean Up.

How do you get air out of a clutch?

To remove the air from your clutch system you need to push or pull the air down through the fluid line to the bleeder valve on the slave cylinder. To keep things clean you should attach a tube to the nipple on the bleeder valve. If you use a clear tube it can be easy to see when all the air has exited the system.

What do I do if my clutch has no pressure?

There could be a leak on the slave cylinder causing the slave cylinder not to operate. Also, check the pin to the clutch pedal and make sure that it is hooked up to the clutch master cylinder. Check the lines and make sure that they are not cross threaded, which will not seal and cause a leak.

How do you know if you have air in your clutch line?

If your clutch pedal feels soft or ‘spongy’ at any point as you press it to the floor, it’s a sign your clutch fluid is low. That spongy, inconsistent feeling is due to air in the clutch line from the master cylinder to the slave cylinder.

How do I know if my clutch needs bleeding?

As far as the hydraulic clutch is concerned, the following symptoms may occur:

1. Change of the pedal travel.
2. Difficulties in disengaging the clutch.
3. Imprecise pedal feel.

How do you bleed a master cylinder without removing it?

Bleeding the Master Cylinder

1. Remove the master cylinder cover and top off the reservoir with fresh brake fluid.
2. Attach a length of clear plastic tubing to the bleeder valve on the master cylinder.
3. Immerse the other end of the clear plastic tube in a plastic or glass container half full with fresh brake fluid.

How do you bleed a clutch with a pressure bleeder?

To bleed your clutch, take the following steps:

1. Jack up the front of the car.
2. Open the hood.
3. Remove the cap from the clutch fluid reservoir.
4. Screw the pressure bleeder onto the top of the reservoir.
5. Pump the clutch a few times.
6. If using a power bleeder, watch the gauge and pump it to a PSI of about 12.