Categories FAQ

Question: How deep is a standard chest of drawers?

A standard chest is taller (44″ – 60″), narrower (30″ – 40″ wide), and about as deep (16″ – 20″) as a standard dresser. You’ll have less counter space with a chest, but your room will feel more open.

What is the average depth of a dresser drawer?

Depth: Standard depths are 14-inches, 16-inches and 20-inches. Height: The height of the drawer refers to the height of the drawer face. The actual height of the box is usually less. Standard heights are 5-inches, 7.5-inches, 10-inches and 12-inches.

How deep should drawers be?

Drawer depth or height is not critical, but the most common difference between the drawer and the opening is 3/4 inch. For example, if the opening measures 4 inches vertically, the drawer should be built 3 1/4 inches. This allows 1/4 inch at the bottom where the slide is attached, and 1/2 inch at the top for clearance.

What is the size of a standard drawer?

Kitchen drawers, or drawer boxes, correspond with the size of your cabinets and their intended uses: For base cabinets, drawers range 6-36″ in width, 4-10″ in height, and just under 24-36″ deep, depending on the depth of the base cabinet (which could also be the island).

You might be interested:  Often asked: How To Bake Sweet Potatoes In Oven With Foil?

How wide should dresser drawers be?

Dresser drawers should be no more than 36 inches wide. Specifically, states Squidoo.com, a “standard size pine chest of drawers” is typically sized in either “17-inch width, 24-inch width, 30-inch width or 36-inch width” drawers.

How do you measure the depth of a drawer?

Begin by measuring along the bottom floor of the drawer at the back edge, middle, and front edge. Check for variations across the height of the drawer as well. Take the smallest of these measurements. Repeat this step for the depth measurement on the left edge, middle, and right edge across the floor and the height.

How do you measure chest of drawers?

Measure from the floor of the drawer to the top of the sides. Do this for the back of the drawer, the sides and the front of the drawer, as panels may differ in measurements around the drawer. Repeat the steps above for every drawer in a dresser (or other furniture piece).

Is a 36 inch drawer too big?

A deep, wide drawer does have a limit in size. You just can’t do a wide drawer at 36 ” wide or more, because it will sag over time, even with heavy duty glides. Homeowners might tend to weigh down that drawer with big, heavy items and you have to account for that happening somewhat.

How big is too big for a drawer?

The rule of thumb is 1.5 times the length of the drawer slide. If you have a standard depth kitchen cabinet then the normal length of drawer slide is 22”. If you multiply 22” x 1.5 = 33”. You can go wider, but the wider you go the more chance that the slide will not pull out as smoothly as you hope or expect.

You might be interested:  Readers ask: Does corn grow in Jamaica?

How thick are drawer slides?

Light duty slides might be as thin as 1/2″, while heavy duty slides may be over 3/4″ thick. Face frame cabinet slides are easier to install using the specific, optional, face frame brackets. Length sizing is usually simplified by checking manufacturer’s charts, where the drawer size and cabinet depth are both stated.

1 звезда2 звезды3 звезды4 звезды5 звезд (нет голосов)
Loading...

Leave a Reply

Your email address will not be published. Required fields are marked *